Skip to main content

Common Settings

Use Serial Console

The Jupiter board has a UART debug serial port, which can be used to view the system startup log, or to log in to the console after the system starts and execute some terminal commands.

USB to TTL serial cable

The pin definitions of common USB to TTL serial cables are as follows:

Document Pictures

Connection

The serial port level is 3.3V, as shown in the figure below, connect the USB to TTL serial port cable, and do not connect the red wire.

Milk-V Jupiter<--->USB to TTL
GND<--->Black wire
RX<--->Green wire (TX)
TX<--->White wire (RX)
Document Pictures

Jupiter's default serial port parameters are as follows:

baudrate: 115200
data bit: 8
stop bit: 1
parity : none
flow control: none
  • carbonfix