๐๏ธ Quick Start
The purpose of this section is to help you get started quickly with Milk-V Titan.
๐๏ธ Hardware Interface
Power interfaces
๐๏ธ DDR4 Support List
The Titan motherboard supports DDR4 UDIMM memory in either single-module or dual-module configurations. For dual-module configurations, using two modules with matching specifications is recommended for best compatibility.
๐๏ธ Install OS
3้ ็ฎ
๐๏ธ Setting Up
Use Serial Console
๐๏ธ RTC Settings
On Ubuntu for Titan, the system reads the RTC (real-time clock) at boot to set the system time. With NTP enabled and network synchronization successful, the system automatically writes the corrected time back to the RTC; this may take a few minutes. Manual setup is normally unnecessary. Use the steps below only if the system or RTC time is incorrect and automatic synchronization has not resolved it.
๐๏ธ SPI Flash Firmware Update
Titan stores the UR-DP1000 boot firmware in SPI Flash. This guide explains how to remove the Flash chip, erase, program, and verify it with an external programmer, then reinstall it and check that the board boots. The hardware photos show Titan V2.1.
๐๏ธ Resource Download
Hardware Design
